Yamaha XVS6501997 Service Manual page 145

CLUTCH
NOTE:
D Apply engine oil onto the friction plates.
D Align the two slots a on the friction plates
with the two punch marks b on the clutch
housing.
*****************************************************
4. Install:
S Push rod #2
S Ball
S Push rod #1 1
S O-ring 2
S Push plate 3
S Washer 4
S Nut 5
NOTE:
Apply lithium soap base grease onto the push
rod and the ball.
5. Install:
S Pressure plate 1
S Clutch springs 2
S Bolts 3
NOTE:
Tighten the pressure plate bolts in stages, using
a crisscross pattern.
6. Check:
S Push lever position
S Push the push lever assembly in the direc-
tion of the arrow and make sure that the
match marks are aligned.
Match marks not aligned. ! Adjust.
a Match mark on the push lever assembly
b Match mark on the crankcase
7. Adjust:
S Push lever position
*****************************************************
Adjustment steps:
D Loosen the nut 1 .
D Turn the push rod #1 2 clockwise or counter-
clockwise so that the match marks are
aligned.
D Tighten the nut 1 .
Nut (clutch adjuster):
8 Nm (0.8 mSkg)
4-41
*****************************************************
ENG
8 Nm (0.8 mSkg)