Shuttle Motion - ProJet 1000 User Manual

Shuttle Motion

On the "Home" page, click on "Advanced" and select "Diagnostic" in the drop down menu to view "Shuttle Motion" screen.
The purpose of the Shuttle Motion page is to allow for the user to correct shuttle errors, and to manually home the shuttle, or fill the tray.
Home Sensor is a readout of the sensor HW when manually enabled.
A
Home Position will allow for the shuttle to move to home position from any other position. If encoder position is lost due to a failure, this is
B
used to regain the shuttle home. Accompanying readout is a target.
Scrape Position is the position to the front of the material tray or front of printer. Accompanying readout is a target.
C
Coat Position is the position to move too, in order to coat or recoat the material tray with material. Accompanying readout is a target.
D
Fill Position is the position to move to in order to actuate the cartridge valves and add material to the material tray. Accompanying readout
E
is a target.
F Current Position is a readout of the current position. Note the values do not have units. Each move has a tolerance of ~0.100 and is not
cumulative.
G Click on the ? to obtain help for this particular screen.