User Diagnostics - ProJet 1000 User Manual

User Diagnostics

User diagnostics should be performed when problems occur to the modeler and also a routine diagnostics should be performed to ensure all
devices are in working order to
prevent problems from arising.
When performing the user diagnostics, the software will check all devices for proper
function and if problems exist, perform the diagnostic test again to ensure the malfunction.
If problem persist, contact your
To access User Diagnostics:
Click on "Diagnostic" located in "Advance" on the home page.
Diagnostic Descriptions
Perform Maintenance Routine: Perform Maintenance Routine enables the shuttle assembly to move back and forth to remove
any excess debris that may be in the tray.
Perform Low Material Tray Fill: enables the printer to perform a routine to add material to a low material tray. Do not over fill
material tray.
Perform New Material Tray Fill: Routine enables the printer to perform a routine to fill a new material tray. NOTE: The material
tray MUST be empty or near empty or this could overflow the material tray.
Start Coat Test: enables the printer to perform a routine to coat the material tray. The user must input the number of cycles.
Material Tray Cure Routine: enables the printer to cure material in material tray before disposing of material tray in alignment
with local standards. NOTE: Once you perform this routine, the current material tray will no longer be capable of printing.
Please discard following the instructions provided by 3DSystems.
Diagnostic Functions
Material Tray Cure Routine
Perform Low Material Tray Fill
Perform New Material Tray Fill
Perform Routine Maintenance
Start Coat Test
3D Systems Technical Support .