Elevator Error Messages - ProJet 1000 User Manual

Elevator Error Messages

ERROR MESSAGE
"ELEVATOR_HOME_FAILURE"
"ELEVATOR_HOME_TIMEOUT"
"ELEVATOR_LEFT_HOME_FAILURE"
"ELEVATOR_RIGHT_HOME_FAILURE"
"ELEVATOR_MOVE_FAILURE"
CAUSE SOLUTION
ELEVATOR DID
1.
NOT GO TO THE
HOME 2.
POSITION. 3.
ELEVATOR
DOES NOT 1.
MOVE.
REMOVE PRINT PLATFORM
OPEN "ELEVATOR MOTION" UNDER ADVANCED\DIAGNOSTICS
CLICK ON HOME ELEVATOR AND SEE IF EACH ONE GOES TO
HOME POSITION
IF RIGHT OR LEFT ELEVATOR DOES NOT HOME, VERIFY
ENCODER CONNECTOR IS PLUGGED IN CORRECTLY.
IF ENCODER IS PLUGGED IN CORRECTLY; POWER OFF
SYSTEM. CHECK FOR ELEVATOR MOTOR PLUGGED IN
CORRECTLY.
POWER ON SYSTEM AND GO BACK TO ELEVATOR
MOTION
4. CHECK HOME SENSORS
BLOCK LEFT HOME SENSOR AND VERIFY LEFT HOME
SENSOR BOX IS CHECKED
BLOCK RIGHT HOME SENSOR AND VERIFY RIGHT HOME
SENSOR BOX IS CHECKED
IF NEITHER IS CHECKED, VERIFY CABLE IS PLUGGED
INTO EACH HOME SENSOR.
IF NONE OF THE ABOVE RESOLVES THE ISSUE,
CONTACT YOU SERVICE REPRESENTATIVE.
REMOVE BUILD PLATFORM
OPEN "ELEVATOR MOTION" UNDER ADVANCED\DIAGNOSTICS
CLICK ON HOME ELEVATOR AND SEE IF EACH ONE GOES TO
HOME POSITION
IF RIGHT OR LEFT ELEVATOR DOES NOT HOME, VERIFY
ENCODER CONNECTOR IS PLUGGED IN CORRECTLY
IF ENCODER IS PLUGGED IN CORRECTLY; POWER OFF
SYSTEM. CHECK FOR ELEVATOR MOTOR PLUGGED IN
CORRECTLY
POWER ON SYSTEM AND GO BACK TO ELEVATOR
MOTION
CHECK HOME SENSORS
BLOCK LEFT HOME SENSOR AND VERIFY LEFT HOME
SENSOR BOX IS CHECKED
BLOCK RIGHT HOME SENSOR AND VERIFY RIGHT HOME
SENSOR BOX IS CHECKED
IF NEITHER IS CHECKED, VERIFY CABLE IS PLUGGED
INTO EACH HOME SENSOR
MOVE ELEVATORS DOWN 0.5-INCHES
VERIFY LEFT AND RIGHT POSITION OUTPUTS SHOW ~
0.5-INCHES AND MOVE DOWN
MOVE ELEVATORS DOWN 2-INCHES
VERIFY LEFT AND RIGHT POSITION OUTPUTS SHOW
~2.5-INCHES AND MOVE DOWN
REPEAT MOVE ELEVATORS DOWN 2-INCHES
MOVE ELEVATORS UP 0.5-INCHES
VERIFY LEFT AND RIGHT POSITION OUTPUTS SHOW ~
0.5-INCHES AND MOVE UP
MOVE ELEVATORS UP 1-INCH
VERIFY LEFT AND RIGHT POSITION OUTPUTS SHOW
~1-INCHES AND MOVE UP
IF NONE OF THE ABOVE RESOLVES THE ISSUE,
CONTACT YOU SERVICE REPRESENTATIVE AND DETAIL
THE MOVE DIRECTION AND ENCODER READOUT FROM
THE ELEVATOR READOUT.