General Safety Guidelines - ProJet 1000 User Manual

General Safety Guidelines

3D Systems' number one priority is to
prevent unsafe operating conditions. One of the safety features in the ProJet™ 1000 / 1500 Personal 3D Printer, it will automatically shut down if
an unsafe condition is detected. However, improper use of the system could result in personal injury.
General Safety Guidelines
To ensure personal safety, follow these general safety guidelines when operating the printing system.
Follow all safety rules in this section and observe all cautions and warnings in this guide.
TO open the door during the printing cycle, press the pause/play button on the machine and then to press the unlock/lock button to open
the door. The system will automatically stop moving parts and then unlock once completely paused. It is only necessary to press the
pause bottom one (1) time then wait for the build cycle for that layer to complete. To resume, press the lock button and then press the
play button.
Do not use part materials without first reviewing its
To prevent tripping, ensure power and communication cables are located away from the walking path to the printing system.
If performing maintenance to this system, ensure step by step instructions are followed and safety precautions are heeded during the
procedure.
Operators of the printer should be trained to perform necessary tasks when printing a part according to the guidelines that are set forth in
this manual. This includes understanding and following the safety and regulatory guidelines.
Do not modify any safety features or make modifications to the printing system. Doing so is prohibited and voids warranty and contractual
agreements.
Use of part materials, print pads or parts other than genuine 3D Systems® ProJet™ 1000 / 1500 components may void warranty and
other contractual agreements.
To prevent potential skin-irritation and sensitization due to contact with the part material, follow all guidelines in Material Safety Data
Sheet (MSDS).
The weight of the printer is approximately 122 lbs. (55.3kg) uncrated and requires two people to lift it. Use standard lifting practices and
always lift with legs bent. Failure to do so could result in serious injury. 3D Systems accepts no liability in the event of back injury due to
the lifting of the printer.
Housekeeping
Protective Eye Wear & Clothing
Take Care of our Customers
Material Safety Data Sheet (MSDS & SDS)
. With that in mind, we want to ensure the safety of our customers and
.