Events - KEB COMBIVERT G6 Programming Manual

7 Events

In case of an occuring event, the device sets the so-called "event flag", which is trans-
mitted in the process data telegram CHECK/STAT byte in bit 7. The master detects the
set bit and reads the reported event. During the reading of an event, no service data can
be exchanged. By this way it is possible to transfer events or states of a device via the
IO-Link master to the PLC or visualization.
The COMBIVERT G6 supports detailed events.
The following events are supported:
The "PD valid" bit in the event service is also set when valid process data are sent from
the power unit to the IO-Link master.
Cur- Eventcode
No.
0x8CA0 (manufacturer
1
specific)
EventQualifier Description
Sent when PD-in count
Instance: Application
fb19 is set to 0, or when
Type: Information
communication to the
Mode: Single shot
power unit is lost or gets
restored.
Events
39