Step 6 Configure The Reader - Microscan MS-3 User Manual

Step 6 — Configure the Reader
See the succeeding chapters and Appendices to see specific configuration command
explanations for both ESP and serial commands.
By ESP
To make change reader settings, or to access the utilities or terminal window, click on
the App Mode button.
To return to the Setup Mode, click on the
By Serial Commands
From your terminal program or the terminal screen in ESP, you can enter serial string
commands configuration and utility commands as described herein.
See "Serial Configuration Commands" on page A-10
Commands" on page
Note: You can learn the current setting of any parameter by inserting a question mark
after the number, as in
You have 2 choices for saving ESP set-
tings to the reader:
• Send, No Save.
This saves ESP settings to current
memory.
• Send and Save.
This activates all changes in current
memory and saves to the reader for
power-on. (Similar to the <Z> command.)
Setup Mode
5-2.
<K100?> To see all "K" commands, send <K?>.
Chapter 1 Quick Start
button.
and "Summary of Utilities
MS-3 CCD Reader User's Manual
1-7