Remote Mount - Emerson Rosemount 702 Reference Manual

Mounting, Wiring Switches, and Output Circuits:
Models 702DX32 and 702DX42
July 2017
7.2.2

Remote mount

1. Install the switch according to standard installation practices being sure to use thread sealant on all of
the connections.
2. Run wiring (and conduit, if necessary) from the switch to the Rosemount 702 Transmitter.
3. Pull the wiring through the threaded conduit entry.
4. Attach the switch wiring to the terminals as shown in the wiring diagrams beginning on
5. If commissioning the transmitter, connect the Black Power Module as shown in
page
Figure 7-4. Remote Mount
A. Float switch
B. Rosemount 702 Transmitter
Note
Use caution when handling the power module, it may be damaged if dropped from heights in excess of
20 ft.
Note
Wireless devices should only be powered up after the Gateway, in order of proximity from the Gateway
beginning with the closest device. This results in a simpler and faster network installation.
6. Close the housing cover and tighten to safety specifications. Always ensure a proper seal by installing
the electronic housing covers so that metal touches metal, but do not over tighten.
7. The antenna should be positioned vertically, typically straight up but the antenna may also be
pointed straight down, as shown in
62
61.
A
B
Figure 7-3 on page 61.
Mounting, Wiring Switches, and Output Circuits: Models 702DX32 and 702DX42
Reference Manual
00809-0200-4702, Rev DA
page 63.
Figure 7-2 on