Remote Mount - Emerson Rosemount 702 Quick Installation Manual

Quick Installation Guide
00825-0100-4702, Rev BA
August 2009
S 1
TEP CONTINUED

Remote Mount

1. Install the switch according to standard installation practices. Be sure to use thread
sealant on all connections.
2. Run wiring (and conduit if necessary) from the switch to the 702.
3. Pull the wiring through the threaded conduit entry of the 702.
4. Attach the switch wiring to the terminals as indicated on the wiring diagram.
5. Connect the battery pack.
NOTE:
Wireless devices should be powered up in order of proximity from the 1420 Wireless
Gateway, beginning with the closest device to the 1420. This will result in a simpler
and faster network installation.
6. Close the housing cover and tighten to safety specification. Always ensure a proper seal
by installing the electronics housing covers so that metal touches metal, but do not over
tighten.
7. Position the antenna such that it is vertical, either straight up or straight down.
...
Rosemount 702
5