Remote Mount - Emerson Rosemount 702 Reference Manual

Reference Manual
00809-0100-4702, Rev AA
September 2007

Remote Mount

NOTE:
Wireless devices should be powered up after the 1420 Wireless Gateway and
in order of proximity from the 1420, beginning with the closest device to the
1420. This will result in a simpler and faster network installation.
5. Close the housing cover and tighten to safety specification. Always
ensure a proper seal by installing the electronics housing covers so
that metal touches metal, but do not over tighten.
6. Position the antenna such that it is vertical, typically straight up
(antenna may be pointed straight down as well).
1. Install the switch/thermocouple according to standard installation
practices. Be sure to use thread sealant on all connections.
2. Run wiring (and conduit if necessary) from the switch/thermocouple
to the 702.
3. Pull the wiring through the threaded conduit entry of the 702.
4. Attach the switch/thermocouple wiring to the terminals as indicated
on the wiring diagram.
5. Connect the battery pack if commissioning.
NOTE
Use caution when handling the battery pack. The battery pack may be
damaged if dropped from heights in excess of 20 feet.
Rosemount 702
Possible antenna rotation shown.
Antenna rotation allows for best
installation practices in any
configuration.
3-3