Safety Messages - Emerson Rosemount 702 Reference Manual

Reference Manual
00809-0200-4702, Rev DA
Section 4
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 27
Configuring the transmitter to communicate with the wireless network . . . . . . . . . . . . . . . . . . . . . page 28
AMS Wireless Configurator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 28
Field Communicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 28
Verifying operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 29
4.1

Safety messages

Instructions and procedures in this section may require special precautions to ensure the safety of the
personnel performing the operations. Information that potentially raises safety issues is indicated by a
warning symbol ( ). Refer to the following safety messages before performing an operation preceded
by this symbol.
Failure to follow these installation guidelines could result in death or serious injury.
Make sure only qualified personnel perform the installation.

Explosions could result in death or serious injury.
Before connecting a Field Communicator in an explosive atmosphere, make sure the instruments are

installed in accordance with intrinsically safe or non-incendive field wiring practices.
Verify that the operating atmosphere of the transmitter is consistent with the appropriate hazardous

locations certifications.
Process leaks could result in death or serious injury.
Do not remove the switch while in operation.

Install and tighten sensors before applying pressure.

Electrical shock could cause death or serious injury.
Use extreme caution when making contact with the leads and terminals.

Note
The Rosemount
after the Gateway has been installed and is functioning properly.
Wireless devices should be powered up in order of proximity from the gateway, beginning with the
device closest to the Emerson
installation.
Commissioning: Models 702DX22 and 702DX61
Commissioning: Models 702DX22
and 702DX61
™
702 Wireless Discrete Transmitter and all other wireless devices should be installed only
™
Wireless Gateway. This will result in a simpler and faster network
Commissioning: Models 702DX22 and 702DX61
July 2017
27