Seagull Models EXTRA 330LX Assembly Manual page 9

INSTALL RUDDER CABLE AND SERVO.
1) Gather one rudder aervo, mounting
screws, servo arm and the rudder control
linkage parts shown below.
38mm
2) Tape the rudder balance tab to the top
leading edge of the vertical fin in the neu-
tral position as shown. This ensures the
rudder is straight when the cables are at-
tached.
3) Thread the rudder cable through a
brass swage tube, then the threaded cou-
pler, and back through the brass swage
tube on both sides. Pull light tension on
the cable through the coupler on both
sides as shown.
M3x15 Socket Head Cap Screw.
Flat washer.
Lock nut.
4) Loop the cable back through the brass
swage tube and tighten the second loop
through the brass swage tube as shown.
5) Crimp the brass tube with a crimping
tool or pliers.
9