Ignition Installation - Seagull Models EXTRA 330LX Assembly Manual

7) Move the throttle stick to the closed po-
sition and move the carburetor to closed.
Use a 2.5mm hex wrench to tighten the
screw that secures the throttle pushrod
wire. Make sure to use threadlock on the
screw so it does not vibrate loose.

IGNITION INSTALLATION.

1) Position the ignition module on the
side of the engine mounting box and
mark the location of the nylon tie holes
as shown.
2) Use a 1/8" bit to drill the ignition mod-
ule mounting holes.
3) Thread nylon tie through mounting
holes.
4) Connect ignition module to pickup
line of engine. Secure with Safety Clip,
safety wire, tape or other method. Ensure
the plugs will not come apart from vibra-
tion or light tension.
5) Secure ignition wire with nylon ties as
necessary.
19