Seagull Models EXTRA 330LX Assembly Manual page 10

EXTRA 330LX
6) Cut off excess cable as shown.
7) Mark and use a 1/16 bit to drill the
rudder servo.
10
Thin CA.
Instruction Manual.
8) Feed one rudder cable through the pre
installed cable exit tube in the rear of the
fuse toward the front of the fuse. Repeat
for other side.
9) Thread cable through brass swage tube.
10) Thread cable through the threaded
coupler hole, and back through the brass
swage tube as shown.
11) Loop the cable back through the brass
swage tube and pull tight.