Figure 89: Removing The Cable Management Bracket - Juniper EX9214 Hardware Manual

Hide thumbs Also See for EX9214:

Table of Contents

Documentation

To remove the cable management bracket:

Attach an ESD grounding strap to your bare wrist and connect the strap to one of the

ESD points on the chassis.

Unscrew the nuts on the corners of the cable management bracket by using the 7/16 in.

(11 mm) nut driver. See

Figure 89: Removing the Cable Management Bracket

Grasp the bottom of the cable management bracket and pull it straight out from the

studs on the chassis.

Installing the Cable Management Bracket in an EX9214 Switch on page 247

Cable Management Bracket in an EX9214 Switch on page 41

Chapter 25: Replacing Cable Management Bracket

Figure 89 on page