Juniper EX9214 Hardware Manual page 252

EX9214 Switch Hardware Guide
228
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
If any transceiver is installed in the MIC, ensure that you cover it by using a rubber
5.
safety cap.
Align the MIC with the guides located along the sides of the MIC slot.
6.
CAUTION: Before you slide the MIC into the slot, ensure that the MIC is
aligned correctly. Misalignment might cause the pins to bend, making the
MIC unusable.
Slide the MIC into the slot gently until it is fully seated (see
7.
Figure 80 on page 230).
Push the MIC ejector lever on the line card that is adjacent to the MIC slot in which
8.
you are installing the MIC until the MIC is secured in position.
If you are installing only one EX9200-10XS-MIC or EX9200-20F-MIC, install a cover
9.
panel over the empty MIC slot and secure it with the captive screws by using the
screwdriver. Do this to protect the interior of the chassis from dust or other foreign
substances and to ensure that the airflow inside the chassis is not disrupted.
Bring the MIC online by pressing the power button on the MIC until the
10.
on the MIC is lit green. You can also bring the MIC online by issuing the following CLI
command:
user@host> request chassis mic fpc-slot slot-number mic-slot slot-number online
Figure 79 on page 229
OK/FAIL
Copyright © 2017, Juniper Networks, Inc.
or
LED