Juniper EX9214 Hardware Manual page 250

EX9214 Switch Hardware Guide
226
Ensure that you have the following parts and tools available:
(If you will install only one EX9200-10XS-MIC or EX9200-20F-MIC) A septum and
screws to secure the septum
(If you will install only one EX9200-10XS-MIC or EX9200-20F-MIC) A cover panel and
screws to secure the cover panel
Rubber safety caps to cover transceivers
ESD grounding strap
Phillips (+) screwdriver, number 2
To install a MIC in an EX9200-MPC line card:
Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD
1.
point on the rear panel of EX9200 switches.
If the MIC slot on the line card has a cover panel on it, use the screwdriver to remove
2.
the captive screws on each side of the cover panel. Save the cover panel and the
screws for later use.
NOTE: If you are installing only one MIC, ensure that the empty MIC slot
is covered by a cover panel.
If you will install only one EX9200-10XS-MIC or EX9200-20F-MIC and if there is no
3.
septum installed in the line card, install the septum (see
Position the septum in the center of the MIC slot on the line card so that it is aligned
a.
with the holes labeled
Insert a screw each into the holes labeled
b.
tighten the screws by using the screwdriver.
Insert a screw each into the holes labeled
c.
and tighten the screws by using the screwdriver.
S on the top and bottom surfaces of the line card.
S on the top surface of the line card and
on the bottom surface of the line card
S
Figure 77 on page 227):
Copyright © 2017, Juniper Networks, Inc.