Juniper EX9214 Hardware Manual page 256

EX9214 Switch Hardware Guide
232
line card and pull them outward simultaneously until the MIC is fully unseated (see
Figure 82 on page 234).
Grasp the handles on the MIC faceplate and slide the MIC out of the line card.
7.
CAUTION: Do not stack MICs on top of one another or on top of any other
component. Place each MIC separately in the antistatic bag or on the
antistatic mat placed on a flat, stable surface.
Place the MIC in an antistatic bag or on its own antistatic mat placed on a flat, stable
8.
surface.
Install both the MIC slot cover panels if you will not install any MIC in the MIC slots, or
9.
install one cover panel in the empty portion of the MIC slot if you will install only one
EX9200-10XS-MIC or EX9200-20F-MIC. Do this to protect the interior of the line card
and the switch chassis from dust or other foreign substances and to ensure that the
airflow inside the line card and the switch chassis is not disrupted.
Copyright © 2017, Juniper Networks, Inc.