Juniper EX9214 Hardware Manual page 181

Copyright © 2017, Juniper Networks, Inc.
Ensure that you have the following parts and tools available:
An ESD grounding strap.
An external management device such as a PC.
A cable to connect the external management device to the
Ethernet management
<...>
For connecting a management device to the console port, see
Switch to a Management Console or an Auxiliary Device" on page
a management device to the Ethernet management port, see
Switch to a Network for Out-of-Band Management" on page
To power on the switch:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Connect the external management device to the Ethernet management (
2.
on the master RE module.
Turn on the power to the external management device.
3.
Ensure that the power supplies are fully inserted in the chassis and that each of their
4.
handles is flush against the faceplate.
Ensure that the source power cord is inserted securely into the appliance inlet for each
5.
AC power supply.
Switch on the dedicated customer site circuit breakers for the power supplies. Follow
6.
the ESD and safety instructions for your site.
Flip the AC input switch on the power supply to the On (
7.
supply faceplate LEDs. If the power supply is installed correctly and functioning
normally, the AC OK and
glow.
Repeat Step 7 for the remaining power supplies installed in the switch.
8.
If any of the status LEDs indicates that the power supply is not functioning normally,
repeat the installation and cabling procedures. See Connecting AC Power to an EX9204
Switch, Connecting AC Power to an EX9208 Switch, or
EX9214 Switch" on page
On the external management device, monitor the startup process to ensure that the
9.
system boots properly.
Chapter 12: Connecting the Switch to Power
port on the master Routing Engine module (RE module).
DC OK LEDs glow steady green. The
154.
CONSOLE port or the
"Connecting an EX9200
166. For connecting
"Connecting an EX9200
165.
) port
<...>
) position. Observe the power
|
PS FAIL LED does not
"Connecting AC Power to an
157