Juniper EX9214 Hardware Manual page 101

Copyright © 2017, Juniper Networks, Inc.
user@host# edit chassis fpc fpc-slot pic pic-number
For example:
[edit ]
user@host# edit chassis fpc 4 pic 0
Configure the pic-mode
2.
You can choose from the options
[edit chassis fpc fpc-slot pic pic-number]
user@host# set pic-mode pic-speed
For example:
[edit chassis fpc 4 pic 0]
user@host# set pic-mode 10G
(Optional) You can choose to configure the number of ports that operate at the speed
3.
configured in Step 2.
[edit chassis fpc fpc-slot pic pic-number]
user@host# set number-of-ports number-of-active-physical-ports
For example, to specify that six ports on PIC 0 operate at the speed specified in Step
2:
[edit chassis fpc 4 pic 0]
user@host# set number-of-ports 6
Verify the configuration.
4.
[edit chassis fpc 4 pic 0]
user@host# show
pic-mode 10G;
number-of-ports 6;
Commit your configuration changes.
5.
Reset the PIC.
6.
If the number-of-ports statement is not configured, all the ports that support the speed
configured in Step 2 are enabled and the others are disabled. That is, the ports are enabled
depending on whether or not they support the speed specified. Ports 0 through 5 are
enabled if the speed specified is 10 Gbps or 40 Gbps; and ports 2 and 5 are enabled and
the other ports of the PIC disabled if the speed specified is 100 Gbps.
lists the physical ports that are enabled when the
statement to set the operating speed for the ports of a PIC.
, , or
10G 40G 100G
number-of-ports
Chapter 5: Line Cards
.
Table 36 on page 78
statement is configured.
77