Juniper EX9214 Hardware Manual page 228

EX9214 Switch Hardware Guide
Related
Documentation
204
On the console or other management device connected to the master Routing Engine,
3.
enter CLI operational mode and issue the
shuts down the Routing Engine gracefully, so its state information is preserved.
Wait until a message appears on the console confirming that the operating system
has halted.
NOTE: The Switch Fabric module (SF module) might continue forwarding
traffic for approximately 5 minutes after the request system halt command
has been issued.
Maintaining Host Subsystem in EX9200 Switches on page 257
Host Subsystem in an EX9200 Switch on page 36
command. The command
request system halt
Copyright © 2017, Juniper Networks, Inc.