Juniper EX9214 Hardware Manual page 133

Copyright © 2017, Juniper Networks, Inc.
The Gigabit Ethernet SFP, SFP+, and QSFP+ transceivers installed in EX4300 switches
support digital optical monitoring (DOM): You can view the diagnostic details for these
transceivers by issuing the operational mode CLI command
.
optics
NOTE: The transceivers support DOM even if they are installed in the SFP+
uplink module ports or QSFP+ ports configured as Virtual Chassis ports
(VCPs).
EX4500—Uplink module ports on EX4500 switches support SFP and SFP+ transceivers.
You can find the list of transceivers supported on EX4500 switches and information
about those transceivers at the
The Gigabit Ethernet SFP and SFP+ transceivers installed in EX4500 switches support
digital optical monitoring (DOM): You can view the diagnostic details for these
transceivers by issuing the operational mode CLI command
.
optics
NOTE: The transceivers support DOM even if they are installed in uplink
module ports configured as Virtual Chassis ports.
EX4550—Uplink module ports on EX4550 switches support SFP, SFP+, and QSFP+
transceivers. You can find the list of transceivers supported on EX4550 switches and
information about those transceivers at the
.
EX4550
The SFP, SFP+, and QSFP+ transceivers installed in EX4550 switches support digital
optical monitoring (DOM): You can view the diagnostic details for these transceivers
by issuing the operational mode CLI command
NOTE: The transceivers support DOM even if they are installed in the
expansion module ports or SFP+ network ports configured as Virtual
Chassis ports (VCPs).
EX4600—The quad small form-factor pluggable plus (QSFP+) ports in EX4600
switches support QSFP+ transceivers, QSFP+ direct-attach copper (DAC) cables, and
DAC breakout cables (DACBO). Each QSFP+ port on an EX4600 switch can be
configured to operate as 10-Gigabit Ethernet interface by using a breakout cable or as
a single 40-Gigabit Ethernet interface. The ports on an EX4600 switch are disabled
by default. You enable a port through the CLI. The 24 downlink or access ports of the
EX4600 switch are 10-Gigabit Ethernet. You can find the list of transceivers supported
on EX4600 switches and information about those transceivers at the
Compatibility Tool page for EX4600
EX6200—Uplink ports on the Switch Fabric and Routing Engine (SRE) module and
line cards in EX6200 switches support SFP and SFP+ transceivers. You can find the
Chapter 8: Transceiver and Cable Specifications
Hardware Compatibility Tool page for EX4500
Hardware Compatibility Tool page for
show interfaces diagnostics optics
.
show interfaces diagnostics
.
show interfaces diagnostics
.
Hardware
109