Trouble Shooting Checklist - Rinnai 650 Operation & Installation Manual

TROUBLE SHOOTING CHECKLIST

Use the following chart to help determine whether a service call is required, however if you are unsure about the
way your heater is operating, contact Rinnai or your local agent.
Condition
Probable
Cause
Not plugged in or turned off
Mains power failure
(Initial Install) Air in gas pipe
Air in hose
Ignition failure
Flat battery for remote control
Gas supply turned off
Gas escape
Blocked / restricted flue system
Insufficient gas pressure
Log Misalignment
Normal operation
Normal operation
Normal operation
Heat switch not activated
Possible fan fault
Controller display blank
Control panel operation
Controller not synchronised
Only applicable when remote control is used.
*
Rinnai
CARE AND MAINTENANCE
Fault
*
**
Fault
Condition
Plug in power cord and turn power 'ON'.
Re-ignition, when power restored.
Installer to purge air from gas supply.
Repeat Ignition procedure.
Repeat Ignition procedure.
Replace remote control battery.
Turn gas supply on at the meter or cylinder.
Isolate gas supply, call Rinnai.
Call Rinnai.
Call Rinnai.
Call Rinnai.
No action is required.
Fan not working - fan automatically comes
on after 4 minutes i.e. once heat switch is
activated.
Allow heater to warm up.
Allow heater to run on high for 4 minutes.
Call Rinnai.
Replace batteries.
Refer to page 12 for solution.
Refer to page 14 for solution.
Only applicable if the remote control is programmed.
**
17
Simplest Possible
Remedy
RDV 600_700 OIM