Burner Media Installation; Ceramic Log Set Installation - Rinnai 650 Operation & Installation Manual

Hide thumbs Also See for 650:

Installation instruction (2 pages)

Operation manual (20 pages)

Table of Contents

CERAMIC LOG SET INSTALLATION

Carefully unpack and inspect each log for damage one at

a time, temporarily returning each of the logs to the

packaging for safe keeping until required. If ANY damage

is evident on the logs DO NOT continue with installation

and contact your supplier for advice.

For clarity the drawings are displayed

without showing the entire heater.

NOTE

Use extreme care when handling the

Ceramic Log Set components, they are

made from a very fragile high temperature

material and will damage if handled

roughly. Only remove the components

from their packaging as required using the

specific order as stated.

Step 1. Removing the Burner Box Glass

A set of instructions is attached to the

burner box glass that has pictures of the

NOTE

suggested stone media placement, ensure

to retain this instruction for use with

"CERAMIC STONE SET INSTALLATION"

on page 38.

While supporting the burner box glass panel in place

unscrew and remove the four retaining screws

unscrewed pull the burner box glass panel away and

place it and the retaining screws safely aside where the

glass and frame can not get damaged or the screws

become lost.

Step 2. Burner Inspection

Check to ensure that the ports of the burner are clean

and clear of any particles and all packaging material.

Step 3. Ember Bed Installation

Remove the stone guard

retaining screws, then gently lift the stone guard out,

taking care to avoid scratching any of the interior surfaces

or fittings.

Fill the perforated ember tray

ember granules

, then take between 6 to 8 pieces of

the black burner granules

over the glass layer of the ember bed.

When satisfied with the placement of the ember bed

material, carefully re-fit the stone guard

Step 4. REAR Log Installation

Identify the "REAR" log and then carefully remove it from

the protective packaging.

Locate the two slots in the base of the log and carefully

place these over the positioning pins

located at the rear of the burner box, ensuring that the

detailed surface of the log is facing out to the front.

Rinnai