Ceramic Stone Set Installation - Rinnai 650 Operation & Installation Manual

CERAMIC STONE SET INSTALLATION

Carefully unpack and inspect each stone for damage one at a time, temporarily returning each of the stones to the
packaging for safe keeping until required. If ANY damage is evident on the stones DO NOT continue with
installation and contact your supplier for advice.
Complete steps 1 through 3 of the CERAMIC LOG SET INSTALLATION - p.36
Step 4 . Remove Log Positioning Pins
When installing stones it is necessary
to remove the Log locating pins as
follows.
The front pins are held into the
A
stone guard by a single screw, undoing
this screw will allow each pin to be
removed.
The rear pins are mounted to support
brackets , each support bracket is
B
attached to the burner box floor with
two screws. The entire pin/bracket
assembly for the pins is to be removed,
however the four fixing screws for the
support brackets MUST BE screwed
back into the floor of the burner box.
Once removed place all the pin components in a safe place as they will be required if a log set is
to be installed in the future.
IMPORTANT
Step 5. Stone Placement
A set of instructions is attached to the burner box glass has pictures of the suggested stone media placement, use
these pictures as a basic guide to the stone placement, the key element to good stone placement is the avoidance
of repetitive patterns, be this due to shape and or colour.
Step 6 . Charcoal Bed Installation
Use the same method described on page 37 Step 5. Charcoal Bed Installation to place the
black burner granules and the brown burner fibre around the stones onto the burner.
DO NOT force any granular or fibrous materials into the burner ports or
completely block any of the burner ports.
IMPORTANT
Keep the flame probe
media.
Step 7 . Replacing the Burner Box Glass
Replace burner box glass panel assembly in the reverse sequence to that explained on page 36 in Step 1.
Removing the Burner Box Glass.
Rinnai
BURNER MEDIA INSTALLATION
free of any direct contact with any of the burner
C
38
A
B
C
DV 600_700 OIM
R