Safety - Rinnai 650 Operation & Installation Manual

• Failure to comply with these instructions could result in a fire or explosion, which could cause
serious injury, death or property damage.
WARNING
• Improper installation, adjustments, service or maintenance can cause serious injury, death or
property damage. Such work must be performed by an authorised person.
• The appliance must be installed in accordance with the local gas and electrical authority
regulations.
• Flue terminal must always vent directly to outdoors.
• DO NOT extend the flue vertically or horizontally in ways other than prescribed in this appliance
manufacturer's installation instructions.
• For information on gas consumption, see data plate on the appliance.
• This appliance MUST NOT be installed where curtains or other combustible materials could
come into contact with it. In some cases curtains may need restraining.
• WARNING: This heater MUST NOT be used if either of the glass panels are damaged.
• When considering
minimum clearances as follows are adhered to:
• Heat radiating from the front of this heater may
over time affect the appearance of some
materials used for flooring such as carpet,
vinyl, cork or timber. This effect may be
amplified if the air in the room contains
cooking vapours or cigarette smoke. To avoid
this possibility, it is recommended that a mat or
similar protective sheet be placed in front of
the appliance, extending at least 750 mm in
front of the dress guard. Refer to page 22 for
mantle clearances,
information and warnings.
• This appliance is NOT intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
• The appliance is NOT intended for use by young children or infirm persons without supervision.
• Young Children must be supervised when in the vicinity of this heater while it is in operation.
• The Dress Guard MUST be fitted to this appliance to reduce the risk injury from serious burns
and no part of it should be permanently removed.
• For protection of young children or the infirm a secondary guard is required.
• If the supply cord is damaged or requires replacing, it must be replaced by the manufacturer or
the manufacturer's agent or similarly qualified person in order to avoid a hazard.
• The heater MUST NOT be located immediately below a power socket outlet.
• A dedicated 240 V earthed 10 Amp power point must be used with this appliance.
• DO NOT modify this appliance. Modifying from original specifications may create a dangerous
situation and will void your warranty.
• Only the flue components specified by Rinnai must be used.
• Unpack the heater and check for damage. DO NOT INSTALL A DAMAGED HEATER. If the heater
is damaged, contact your supplier for advice.
• Before installing the heater, check the label for the correct gas type (refer rating plate, inside the
appliance).
• Refer to local gas authority for confirmation of the gas type if you are in doubt.
• Suitable ONLY for indoor installation.
• DO NOT operate this appliance before leak checking hoses and gas cylinder connection.
• NOT to be connected to an LP gas cylinder located indoors.
Rinnai

SAFETY

installation ensure
additional installation
6
Note: The three sided fascia is shown for illustrative purposes
RDV 600_700 OIM