Huawei NetEngine5000E Configuration Manual page 194

HUAWEI NetEngine5000E Core Router
Configuration Guide - System Management
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure an IP address for each interface.
# Configure an IP address and a mask for each interface (including loopback interfaces) as
described in
Step 2 Configure the LDP session between every two Routers.
# Configure OSPF to advertise the host routes of the specified LSR ID and of the network
segments to which interfaces on the router are connected. Enable basic MPLS functions on each
router and its interfaces.
For configurations of the static MPLS TE tunnel, see the chapter "MPLS Basic Configurations"
in the HUAWEI NetEngine5000E Core Router Configuration Guide - MPLS.
Step 3 Enable NetStream on POS 1/0/0 of Router B.
# Configure the NetStream service processing mode on an LPU.
<RouterB> system-view
[~RouterB] slot 1
[~RouterB-slot-1] ip netstream sampler to slot 4
[~RouterB-slot-1] return
# Configure NetStream to collect statistics about incoming and outgoing packets on POS 1/0/0
of Router B.
[~RouterB] interface pos 1/0/0
[~RouterB-Pos1/0/0] ip netstream inbound
[~RouterB-Pos1/0/0] ip netstream outbound
[~RouterB-Pos1/0/0] quit
# Configure NetStream to sample both inner IP packets and labels of MPLS packets.
[~RouterB] ip netstream mpls-aware label-and-ip
# Configure the destination address, destination port number, and source address for NetStream
flows output in V5 format.
[~RouterB] ip netstream export host 192.168.1.2 2100
[~RouterB] ip netstream export source 10.1.2.1
Issue 01 (2011-10-15)
Configure the LDP session between every two Routers.
Configure the remote peer and its IP address on the two Routers that have established a
remote LDP session.
Configure the destination IP address, destination port number, and source IP address of
NetStream flows to be output.
IP addresses of interfaces on each router as shown in
Area 0
Remote peer of router A, whose name is router c and the IP address is 3.3.3.9.
Remote peer of router C, whose name is router a and the IP address is 1.1.1.9.
Number of the slot where the NetStream service processing board resides (In this example,
the NetStream service processing board is in slot 4.)
Figure 6-15. Details for the configuration procedure are not provided here.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NetStream Configuration
Figure 6-15, OSPF process 1, and
186