Table of Contents
Advertisement
HUAWEI NetEngine5000E Core Router
Configuration Guide - System Management
l
----End
5.5 Configuration Examples
This section provides an example for configuring FM.
5.5.1 Example for Configuring FM
This section describes how to configure FM.
Networking Requirements
On a single NE5000E, an interface is numbered in the format of slot number/card number/
interface number. In the multi-chassis scenario, an interface is numbered in the format of chassis
ID/slot number/card number/interface number. This requires the chassis ID to be specified along
with the slot number.
As shown in
Figure 5-1 Networking diagram for configuring FM
Router
When a fault occurs on a network, FM can be configured to help users rapidly locate the fault
and rectify the fault.
Issue 01 (2011-10-15)
The alarm configurations are displayed.
The keyword brief is configured in this command to display the basic information about
an alarm, such as the feature for which the alarm is generated, alarm name, alarm ID, alarm
severity, and alarm suppression period.If the keyword brief is not configured in this
command, the reason why this alarm is generated and rectification solution are displayed,
in addition to the basic information.
Run:
display alarm statistics [ name alarm-name ]
Alarm statistics are displayed.
If an alarm name is specified in this command, only the statistics about the specified alarm
are displayed. If no alarm name is specified in this command, statistics about all alarms are
clarified and displayed.
CAUTION
Figure
5-1, a user logs in to the Router.
IP
Network
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
User
5 Fault Management
121
Advertisement
Table of Contents
