How To Disable The Wi-Fi Network Connected; Wi-Fi Direct Mode; Preliminary Preparations; Wi-Fi Direct Connection - Pantum M6700 Series User Manual

5.1.2.2.Wi-Fi Protected Setup (WPS) method
1. Turn on the power of printer and access point (wireless router).
2. Make sure the printer is in ready state.
3. Press the "Wi-Fi key" on the control panel of printer for more than 2s until the blue
Wi-Fi indicator of printer blinks, and then release pressing.
4. Press the WPS key on access point (wireless router) within 2min and then release it.
5. When the access point (wireless router) and printer start to connect, the blue Wi-Fi
indicator of printer starts to blink. The blue Wi-Fi indicator of printer will be normally on
after successful connection
If the connection is not established after more than 2min, the printer will return to its ready
state, the Wi-Fi indicator will be off
fail. If it is needed to connect again, please repeat steps 3-4 above.
Note: Please refer to
·
· After successful Wi-Fi Protected Setup (WPS) connection, please install a driver
if you want to print via wireless network. Please select "Wireless network
connection (W)" as installation method (please refer to
Windows system and

5.1.3.How to disable the Wi-Fi network connected

IPlease complete the wireless network connection in infrastructure mode according to above
steps. If connected, the Wi-Fi indicator on the status control panel will be always on
now if you want to disconnect it, please press and hold this key for more than 2 seconds
(the Wi-Fi indicator will be off

5.2.Wi-Fi Direct mode

You can connect wireless client (including the computer and mobile device with wireless
network feature) to wireless network printer without using the access point (wireless router).

5.2.1.Preliminary preparations

1. Printer with the Wi-Fi Direct feature.
2. Wireless client (including computer and mobile device with wireless network feature).

5.2.2.Wi-Fi Direct connection

The Wi-Fi Direct connection feature of printer must be on if it is needed. The method to turn it on
is: pressing the "Menu key" – "Menu Setting" – "Network Set" – "Wi-Fi dir." – "Manual" (or "Auto")
of the control panel of printer, or logging in the embedded Wed server to turn it on, please refer
to Chapter 6.2.2.4.
5.2.2.1.Connection method of wireless client that supports Wi-Fi Direct
feature (direct invitation to connect)
You must use mobile devices that support Wi-Fi Direct function for Wi-Fi Direct connection.
The operating steps may differ because of the mobile device you are using.
1. Turn on printer power.
.
and Wi-Fi Protected Setup (WPS) connection will
Chapter 1.5 for how to cancel and disconnect Wi-Fi connection.
Chapter 3.3.3
).
Chapter 3.1.3
for Mac system).
for
38