Main Menu - Danfoss VLTAutomationDrive FC 360 Quick Manual

User Interface and Programm...

4.3 Main Menu

The Main Menu gives access to all parameters.
1. To enter the Main Menu, press [Menu] key until
indicator in display is placed above Main Menu.
▲ ▼
2.
[ ] [
3. Press [OK] to select a parameter group.
▲ ▼
4.
[ ] [
specific group.
4 4
5. Press [OK] to select the parameter.
6.
[►] and [
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice (or three times
for array parameters) to enter Main Menu, or
press [Menu] once to enter Status.
The principles for changing the value of continuous,
enumerated and array parameters, respectively, are shown
below.
OK
1
2 x
2
+ OK
OK 3
4
5
6
7
8
Illustration 4.5 Main Menu Interactions - Continuous Parameters
22
VLT
]: browse through the parameter groups.
]: browse through the parameters in the
▲ ▼
] [ ]: set/change the parameter value.
Setup 1
12
Setup 1
10
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
MG06A102 - VLT
®
AutomationDrive FC 360 Quick Guide
1 [OK]: the first parameter in the group is shown.
2
Press [
parameter.
3 Press [OK] to start editing.
4 [►]: first digit flashing (can be edited).
5
[►]: second digit flashing (can be edited).
6
[►]: third digit flashing (can be edited).
▼
7
[ ]: decreases the parameter value, the decimal point
changes automatically
▲
8
[ ]: increases the parameter value.
9 [Back]: cancel changes, return to 2)
[OK]: accept changes, return to 2)
▲ ▼
10
[ ][
11 [Back]: Removes the value and shows the parameter group.
▲ ▼
12
[ ][
Table 4.4
For enumerated parameters the interaction is similar but
the parameter value is shown in brackets, because of the
NLCP digits limitation (4 large digits) and the enum can be
greater than 99. When the enum value is greater than 99,
the NLCP can only display the first part of the bracket.
11
1
OK
OK 2
Illustration 4.6 Main Menu Interactions - Enumerated Parameters
9
1 [OK]: the first parameter in the group is shown.
OK
2 Press [OK] to start editing.
▲ ▼
3
[ ][
4 Press [Back] to cancel changes or [OK] to accept changes
(return to screen 2).
▲ ▼
5
[ ][
6 [Back]: Removes the value and shows the parameter group.
▲ ▼
7
[ ][
Table 4.5
®
is a registered Danfoss trademark
▼
] repeatedly to move down to the desired
]: select parameter within the group.
]: select group.
Setup 1
Setup 1
Setup 1
]: change parameter value (flashing).
]: select parameter within the group.
]: select group.
7
6
5
4
OK
3