System Requirements; Electromagnetic Compatibility; Electromagnetic Emission - Sirona inEos X5 Operating Instructions Manual

4 Technical description
4.4 System requirements
Tests/approvals
Emission measurement
RF emissions according to CISPR 11
RF emissions according to CISPR 11
Harmonics
according to IEC 61000-3-2
Voltage fluctuations / flicker according
to IEC 61000-3-3
16
This unit complies with the following requirements:
DIN EN 61 010-1: 2011 (safety)
DIN EN 61 326-1: 2006 (EMC)
DIN EN ISO 12 100: 2011 (risk management)
4.4

System requirements

A 64-bit inLab 4 PC is required to run this software. The hardware version
must be PC hardware version 2.0.1 or higher.
4.5

Electromagnetic compatibility

Observance of the following information is necessary to ensure safe
Fragment: inEos X5
operation regarding EMC aspects.
inEos X5 complies with the requirements for electromagnetic
compatibility (EMC) according to DIN EN 61326-1:2006-10.
inEos X5 is hereinafter referred to as "UNIT".
4.5.1

Electromagnetic emission

The UNIT is intended for operation in the electromagnetic environment
specified below.
The customer or user of the UNIT should make sure that it is used in such
an environment.
Conformity
Group 1
Class B
Class A
coincides
Operating Instructions inEos X5
Electromagnetic environment - guidelines
The UNIT uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
The UNIT is intended for use in all facilities,
including residential areas and in any facilities
connected directly to a public power supply
providing electricity to buildings used for residential
purposes.
Sirona Dental Systems GmbH
64 17 096 D3586
D3586.201.01.06.02 11.2016