Performing 3D Acquisition; General; Acquisition Methods - Sirona inEos X5 Operating Instructions Manual

9 Performing 3D acquisition
9.1 General
34
9

Performing 3D acquisition

9.1

General

9.1.1

Acquisition methods

Four methods are available for acquiring scans with the inEos X5:
● Automatic jaw scan
– For all tasks
– Especially for large, complex tasks or tasks with high accuracy
requirements
● Free jaw scan
– For simple tasks
– For free detail scans under various angles
● Individual stump scan (rotation scan)
– For the measurement of one or more single tooth stumps
– For single restorations without consideration of the proximal
contacts or the antagonist
● Scanbody scan
– For the measurement of one or more inPost scanbodies
Tip: You can execute several scan methods in sequence. You can omit a
scan method if, for example, it is either not suitable or is not required for
your model.
IMPORTANT
Perform the individual stump scans either completely prior to or after the
automatic and/or free scans.
It is not possible (for example) to initially perform an automatic scan,
then carry out a scan of individual stumps, and, finally, to change back
to automatic mode once again.
Tip: For stump model tasks, first take the scans of the prepared stumps.
Then add automatic and/or free scans. In this way, you can reduce the
processing time.
Sirona Dental Systems GmbH
Operating Instructions inEos X5
64 17 096 D3586
D3586.201.01.06.02 11.2016