Camera Management; Camera Signal - Vitek VT-TR5HA1620 Manual

Transcendent VT-TR5HA DVR Series
4.1

Camera Signal

Click StartàSettingsàCameraàManage CameraàCamera Signal to go to the interface as
shown below.
The DVR supports hybrid access of TVI, AHD and CVI high definition cameras. If a TVI high
definition camera is connected to the DVR, you should select TVI in the following interface to
show the camera image; if you select AHD, then there will be no image or the image has no
color. The default selection of the camera signal is Auto. If you select Auto, the image of the
camera will be shown normally regardless of the camera type.
You can enable "Lite" in the interface if the DVR supports "Lite" recording. It will lower the
recording resolution and increase the recording frame rate. Please enable or disable the Lite as
you wish.
Analog / IP
While the DVR can add additional cameras through the use of IP cameras 1(3mp) on the 4ch
and 4(4mp) on the 8 & 16 channel units you are able to change the hard input channels into IP
channels (4 + 1 on the 4ch and 8 + 4 on the 8 & 16 channel)

4 Camera Management

27