Ipv6 Mpls L3Vpn Configuration Examples; Configuring Ipv6 Mpls L3Vpns - HP 10500 Series Configuration Manual

IPv6 MPLS L3VPN configuration examples

Configuring IPv6 MPLS L3VPNs

Network requirements
CE 1 and CE 3 belong to VPN 1. CE 2 and CE 4 belong to VPN 2.
VPN 1 uses route target attributes 1 1 1:1. VPN 2 uses route target attributes 222:2. Users of different VPNs
cannot access each other.
Run EBGP between CE and PE switches to exchange VPN routing information.
PEs use OSPF to communicate with each other and use MP-IBGP to exchange VPN routing information.
Figure 54 Network diagram
Device
CE 1
PE 1
CE 2
CE 3
CE 4
Configuration procedure
Configure OSPF on the MPLS backbone to achieve IP connectivity among the PEs and the P switch:
1.
# Configure PE 1.
<PE1> system-view
Interface IP address
Vlan-int11 2001:1::1/96
Loop0 1.1.1.9/32
Vlan-int11 2001:1::2/96
Vlan-int13 172.1.1.1/24
Vlan-int12 2001:2::2/96
Vlan-int12 2001:2::1/96
Vlan-int11 2001:3::1/96
Vlan-int13 2001:4::1/96
Device Interface
P Loop0
Vlan-int12
Vlan-int13
PE 2 Loop0
Vlan-int12
Vlan-int11
Vlan-int13
193
IP address
2.2.2.9/32
172.2.1.1/24
172.1.1.2/24
3.3.3.9/32
172.2.1.2/24
2001:3::2/96
2001:4::2/96