HP 10500 Series Configuration Manual page 268

# Create a cross-connect group named vpn1, create a cross-connect named ldp in the group, bind
service instance 1000 on Ten-GigabitEthernet 1/0/1 to the cross-connect, and create an LDP PW
for the cross-connect to bind the AC to the PW.
[PE2] xconnect-group vpn1
[PE2-xcg-vpn1] connection ldp
[PE2-xcg-vpn1-ldp] ac interface ten-gigabitethernet1/0/1 service-instance 1000
[PE2-xcg-vpn1-ldp] peer 192.3.3.3 pw-id 1000
[PE2-xcg-vpn1-ldp-192.3.3.3-1000] quit
[PE2-xcg-vpn1-ldp] quit
[PE2-xcg-vpn1] quit
Configure CE 2:
6.
<CE2> system-view
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
[CE2-Vlan-interface10] quit
Verify the configuration
# Display L2VPN PW information on PE 1. The output shows that a PW has been created.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.2.2.2
# Display L2VPN PW information on ASBR 1. The output shows that two PWs have been created to form
a multi-segment PW.
[ASBR1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 2, 2 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.1.1.1
192.3.3.3
# Display L2VPN PW information on ASBR 2. The output shows that two PWs have been created to form
a multi-segment PW.
[ASBR2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 2, 2 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.2.2.2
192.4.4.4
# Display L2VPN PW information on PE 2. The output shows that a PW has been created.
PW ID In/Out Label
1000 65661/65659
PW ID In/Out Label
1000 65659/65661
1000 65658/65661
PW ID In/Out Label
1000 65661/65658
1000 65665/65659
Proto Flag
LDP M
Proto Flag
LDP M
LDP M
Proto Flag
LDP M
LDP M
262
Link ID State
1 Up
Link ID State
0 Up
1 Up
Link ID State
0 Up
1 Up