Configuring Routing Between A Pe And A Ce - HP 10500 Series Configuration Manual

Step
5. Apply an import routing
policy.
6. Apply an export routing
policy.
7. Apply a tunnel policy to the
VPN instance.

Configuring routing between a PE and a CE

You can configure IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, or EBGP between a PE and a CE.
Configuring IPv6 static routing between a PE and a CE
Step
1. Enter system view.
Command
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
Command
system-view
184
Remarks
By default, all routes matching the
import target attribute are
accepted.
Make sure the routing policy
already exists. Otherwise, the
device does not filter received
routes.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
Make sure the routing policy
already exists. Otherwise, the
device does not filter routes to be
advertised.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing) in this
order: LSP tunnel, GRE tunnel,
CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "Configuring tunnel
policies."
Remarks
N/A