HP 10500 Series Configuration Manual page 205

[PE2-bgp] ipv6-family vpnv6
[PE2-bgp-af-vpnv6] peer 1.1.1.9 enable
[PE2-bgp-af-vpnv6] quit
[PE2-bgp] quit
After completing the configurations, execute the display bgp peer vpnv6 command on the PEs. The
output shows a BGP peer relationship has been established between the PEs and has reached the
Established state.
Verify the configuration:
6.
# Execute the display ipv6 routing-table vpn-instance command on the PEs. The output shows the
routes to the CEs. Take PE 1 as an example:
[PE1] display ipv6 routing-table vpn-instance vpn1
Destinations : 6 Routes : 6
Destination: ::1/128
NextHop : ::1
Interface : InLoop0
Destination: 2001:1::/96
NextHop : ::
Interface : Vlan11
Destination: 2001:1::2/128
NextHop : ::1
Interface : InLoop0
Destination: 2001:3::/96
NextHop : ::FFFF:3.3.3.9
Interface : Vlan13
Destination: FE80::/10
NextHop : ::
Interface : NULL0
Destination: FF00::/8
NextHop : ::
Interface : NULL0
[PE1] display ipv6 routing-table vpn-instance vpn2
Destinations : 6 Routes : 6
Destination: ::1/128
NextHop : ::1
Interface : InLoop0
Destination: 2001:2::/96
NextHop : ::
199
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : BGP4+
Preference: 255
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0