HP 10500 Series Configuration Manual page 157

[PE1] mpls ldp
[PE1-ldp] quit
[PE1] isis 1
[PE1-isis-1] network-entity 10.0000.0000.0000.0004.00
[PE1-isis-1] quit
[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
[PE1] interface vlan-interface 12
[PE1-Vlan-interface12] ip address 30.1.1.1 24
[PE1-Vlan-interface12] isis enable 1
[PE1-Vlan-interface12] mpls enable
[PE1-Vlan-interface12] mpls ldp enable
[PE1-Vlan-interface12] mpls ldp transport-address interface
[PE1-Vlan-interface12] quit
[PE1] bgp 100
[PE1-bgp] peer 4.4.4.9 as-number 100
[PE1-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-vpnv4] peer 4.4.4.9 enable
[PE1-bgp-vpnv4] quit
[PE1-bgp] quit
# Configure PE 2 in the same way that PE 1 is configured. (Details not shown.)
After completing the configurations, execute the display mpls ldp peer command on PE 1 or PE 2
to see that the LDP session has been established. Execute the display bgp peer vpnv4 command to
see that the BGP peer relationship has been established and has reached the Established state.
Execute the display isis peer command to see that the IS-IS neighbor relationship has been set up.
Take PE 1 as an example:
[PE1] display mpls ldp peer
Total number of peers: 1
Peer LDP ID
4.4.4.9:0
[PE1] display bgp peer vpnv4
BGP local router ID: 3.3.3.9
Local AS number: 100
Total number of peers: 1
Peer
4.4.4.9
[PE1] display isis peer
System Id: 0000.0000.0005
Interface: Vlan-interface12
State: Up HoldTime:
State LAM
Operational DU
AS MsgRcvd
100 3
Peer information for ISIS(1)
----------------------------
Circuit Id: 0000.0000.0005.02
8s Type: L1(L1L2)
151
Role GR MD5
Active Off Off
Peers in established state: 1
MsgSent OutQ PrefRcv Up/Down
6 0
PRI: 64
KA Sent/Rcvd
8/8
State
0 00:00:32 Established