Configuring Ldp Backoff - HP 10500 Series Configuration Manual

Step
2. Enter interface view.
3. Configure the Keepalive hold
time.
4. Configure the Keepalive
interval.
5. Configure the LDP transport
address.
Configuring LDP sessions parameters for Extended Discovery mechanism
To configure parameters for LDP sessions to be established using Extended Discovery mechanism:
Step
1. Enter system view.
2. Enter LDP view.
3. Specify an LDP peer and enter
LDP peer view. The device will
send unsolicited Targeted
Hellos to the peer and can
respond to Targeted Hellos sent
from the targeted peer.
4. Configure the Keepalive hold
time.
5. Configure the Keepalive
interval.
6. Configure the LDP transport
address.

Configuring LDP backoff

If LDP session parameters (for example, the label advertisement mode) are incompatible, two LDP peers
cannot establish a session, and they will keep negotiating with each other.
Command
interface interface-type
interface-number
mpls ldp timer keepalive-hold
timeout
mpls ldp timer keepalive-interval
interval
mpls ldp transport-address
{ ip-address | interface }
Command
system-view
mpls ldp
targeted-peer peer-lsr-id
mpls ldp timer keepalive-hold
timeout
mpls ldp timer keepalive-interval
interval
mpls ldp transport-address
ip-address
66
Remarks
N/A
By default, the Keepalive hold time
is 45 seconds.
By default, the Keepalive interval is
15 seconds.
By default, the LDP transport
address is the LSR ID of the local
device if the interface where you
want to establish an LDP session
belongs to the public network. If
the interface belongs to a VPN, the
LDP transport address is the
primary IP address of the interface.
If the interface where you want to
establish an LDP session is bound
to a VPN instance, the interface
with the IP address specified with
this command must be bound to the
same VPN instance.
Remarks
N/A
N/A
By default, the device does not
send Targeted Hellos to or
receive Targeted Hellos from
any peer.
By default, the Keepalive hold
time is 45 seconds.
By default, the Keepalive interval
is 15 seconds.
By default, the LDP transport
address is the LSR ID of the local
device.