HP 10500 Series Configuration Manual page 156

PE 3 and PE 4 are the customer carrier's PE switches. They provide MPLS L3VPN services for the end
•
customers.
CE 3 and CE 4 are customers of the customer carrier.
•
The key to carrier's carrier deployment is to configure exchange of two kinds of routes:
Exchange of the customer carrier's internal routes on the provider carrier's backbone.
•
Exchange of the end customers' VPN routes between PE 3 and PE 4, the PEs of the customer carrier.
•
In this process, an MP-IBGP peer relationship must be established between PE 3 and PE 4.
Figure 48 Network diagram
Device
CE 3
PE 3
CE 1
PE 1
Configuration procedure
Configure MPLS L3VPN on the provider carrier backbone. Enable IS-IS as the IGP, enable LDP
1.
between PE 1 and PE 2, and establish an MP-IBGP peer relationship between the PEs:
# Configure PE 1.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 3.3.3.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 3.3.3.9
Interface IP address
Vlan-int11 100.1.1.1/24
Loop0 1.1.1.9/32
Vlan-int11 100.1.1.2/24
Vlan-int12 10.1.1.1/24
Loop0 2.2.2.9/32
Vlan-int12 10.1.1.2/24
Vlan-int11 11.1.1.1/24
Loop0 3.3.3.9/32
Vlan-int11 11.1.1.2/24
Vlan-int12 30.1.1.1/24
Device Interface
CE 4 Vlan-int11
PE 4 Loop0
Vlan-int11
Vlan-int12
CE 2 Loop0
Vlan-int11
Vlan-int12
PE 2 Loop0
Vlan-int12
Vlan-int11
150
IP address
120.1.1.1/24
6.6.6.9/32
120.1.1.2/24
20.1.1.2/24
5.5.5.9/32
21.1.1.2/24
20.1.1.1/24
4.4.4.9/32
30.1.1.2/24
21.1.1.1/24