HP 10500 Series Configuration Manual page 253

[PE2-Ten-GigabitEthernet1/0/1] service-instance 1000
[PE2-Ten-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 10
[PE2-Ten-GigabitEthernet1/0/1-srv1000] quit
[PE2-Ten-GigabitEthernet1/0/1] quit
# Create a cross-connect group named vpn1, create a cross-connect named ldp in the group, bind
service instance 1000 on Ten-GigabitEthernet 1/0/1 to the cross-connect, and create an LDP PW
for the cross-connect to bind the AC to the PW.
[PE2] xconnect-group vpn1
[PE2-xcg-vpn1] connection ldp
[PE2-xcg-vpn1-ldp] ac interface ten-gigabitethernet1/0/1 service-instance 1000
[PE2-xcg-vpn1-ldp] peer 192.2.2.2 pw-id 1000
[PE2-xcg-vpn1-ldp-192.2.2.2-1000] quit
[PE2-xcg-vpn1-ldp] quit
[PE2-xcg-vpn1] quit
Configure CE 2:
5.
<CE2> system-view
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
[CE2-Vlan-interface10] quit
Verify the configuration
# Display L2VPN PW information on PE 1. The output shows that an LDP PW has been established.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.3.3.3
# Display L2VPN PW information on PE 2. The output shows that an LDP PW has been established.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.2.2.2
# CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
56 bytes from 100.1.1.2: icmp_seq=0 ttl=255 time=8.000 ms
56 bytes from 100.1.1.2: icmp_seq=1 ttl=255 time=4.000 ms
56 bytes from 100.1.1.2: icmp_seq=2 ttl=255 time=19.000 ms
56 bytes from 100.1.1.2: icmp_seq=3 ttl=255 time=3.000 ms
56 bytes from 100.1.1.2: icmp_seq=4 ttl=255 time=6.000 ms
--- 100.1.1.2 ping statistics ---
PW ID In/Out Label
1000 65662/65660
PW ID In/Out Label
1000 65669/65655
Proto Flag
LDP M
Proto Flag
LDP M
247
Link ID State
1 Up
Link ID State
1 Up