Ldp Pw Configuration Example - HP 10500 Series Configuration Manual

[PE3-vsi-svc] quit
# Create service instance 10 on Ten-GigabitEthernet1/0/1 to match all packets, and bind the
service instance to the VSI svc.
[PE3] interface ten-gigabitethernet1/0/1
[PE3-Ten-GigabitEthernet1/0/1] service-instance 10
[PE3-Ten-GigabitEthernet1/0/1-srv10] encapsulation default
[PE3-Ten-GigabitEthernet1/0/1-srv10] xconnect vsi svc
[PE3-Ten-GigabitEthernet1/0/1-srv10] quit
Verifying the configuration
# Execute the display l2vpn pw verbose command on PE 1. The output shows two static PWs in up state
have been established.
[PE1] display l2vpn pw verbose
VSI Name: svc
Peer: 2.2.2.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
Tunnel Group ID
Tunnel NHLFE IDs
Peer: 3.3.3.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
Tunnel Group ID
Tunnel NHLFE IDs

LDP PW configuration example

Network requirements
Configure VPLS on each PE, and establish LDP PWs between the PEs to interconnect the CEs.
PW ID: 3
: Static
: 8 PW State : Up
: 100 Out Label: 100
: 1500
: Main
: 0x1800000760000005
: 133
PW ID: 3
: Static
: 9 PW State : Up
: 200 Out Label: 200
: 1500
: Main
: 0x1800000860000006
: 135
278