Configuring An Ldp Pw (Flexible Mode) - HP 10500 Series Configuration Manual

--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/stddev = 0.125/0.148/0.176/0.022 ms

Configuring an LDP PW (flexible mode)

Network requirements
Create an LDP PW between PE 1 and PE 2, and use flexible mode to match specific packets from each
AC so CE 1 and CE 2 can communicate within VLAN 10 without consuming VLAN resources on PEs.
Figure 67 Network diagram
Device
CE 1
PE 1
CE 2
Configuration procedure
Before you perform the following configurations, configure VLANs and add ports to VLANs on CEs.
Configure CE 1:
1.
<CE1> system-view
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
[CE1-Vlan-interface10] quit
Configure PE 1:
2.
# Configure an LSR ID.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
# Enable L2VPN.
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int23 23.1.1.1/24
Vlan-int10 100.1.1.2/24
Device Interface
P Loop0
Vlan-int23
Vlan-int26
PE 2 Loop0
Vlan-int26
244
IP address
192.4.4.4/32
23.1.1.2/24
26.2.2.2/24
192.3.3.3/32
26.2.2.1/24