Configuring A Service Instance On A Layer 2 Ethernet Interface; Configuring A Cross-Connect - HP 10500 Series Configuration Manual

Configuring a service instance on a Layer 2 Ethernet interface

When the PE connects to a CE through a Layer 2 Ethernet interface, you can configure a service instance
on the Layer 2 Ethernet interface to match specific packets from the AC.
To configure a service instance:
Step
Enter system view.
1.
2. Enter Layer 2 Ethernet
interface view.
3. Create a service instance
and enter service instance
view.
4. Configure match criteria for
the service instance.

Configuring a cross-connect

Step
Enter system view.
1.
2. Create a cross-connect group
and enter cross-connect group
view.
3. (Optional.) Configure a
description for the
cross-connect group.
4. (Optional.) Enable the
cross-connect group.
5. Create a cross-connect and
enter cross-connect view.
6. Configure an MTU for the
cross-connect.
Command
system-view
interface interface-type
interface-number
service-instance instance-id
•
Match all incoming packets:
encapsulation default
•
Match incoming packets with
any VLAN ID or no VLAN ID:
encapsulation { tagged |
untagged }
•
Match incoming packets with a
specific VLAN ID:
encapsulation s-vid vlan-id
[ only-tagged ]
Command
system-view
xconnect-group group-name
description text
undo shutdown
connection connection-name
mtu mtu
231
Remarks
N/A
N/A
By default, no service instance is
created.
Use one of the commands.
By default, no match criteria are
configured for the service instance.
Remarks
N/A
By default, no cross-connect group
is created.
By default, no description is
configured for the cross-connect
group.
By default, the cross-connect group
is enabled.
By default, no cross-connect is
created.
The default MTU is 1500 bytes.
The two PEs at the ends of an LDP
PW must have the same MTU on
the cross-connect. Otherwise, the
PW cannot go up.