Configuring An Ldp Pw; Binding An Ac To A Vsi - HP 10500 Series Configuration Manual

Step
1. Enter system view.
2. Enter VSI view.
3. Configure the VSI to
establish a static PW,
and enter VSI static view.
4. Configure a VPLS PW
and enter VSI static PW
view.

Configuring an LDP PW

Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information about
MPLS LDP configuration, see
To configure an LDP PW:
Step
1. Enter system view.
2. Enter VSI view.
3. Configure the VSI to
use LDP to establish a
PW, and enter VSI LDP
view.
4. Configure a VPLS PW
and enter VSI LDP PW
view.

Binding an AC to a VSI

This task is mutually exclusive with Ethernet link aggregation. If a Layer 2 Ethernet interface has been
added to a link aggregation group, you cannot bind a service instance on the interface to a VSI, and
vice versa.
After you bind a service instance on a Layer 2 Ethernet interface to a VSI, packets that are received from
the Layer 2 Ethernet interface and meet the match criteria of the service instance are forwarded based on
the MAC address table bound to the VSI. A service instance can match all packets, tagged packets, or
untagged packets.
To bind a service instance to a VSI:
Step
1. Enter system view.
Command
system-view
vsi vsi-name
pwsignaling static
peer ip-address pw-id pw-id
in-label label-value out-label
label-value [ pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
"Configuring LDP."
Command
system-view
vsi vsi-name
pwsignaling ldp
peer ip-address pw-id pw-id [ hub |
no-split-horizon | pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
Command
system-view
271
Remarks
N/A
N/A
By default, no PW signaling protocol is
specified.
By default, no VPLS PW is configured.
Remarks
N/A
N/A
By default, no PW signaling protocol is
specified.
By default, no LDP PW is configured.
Remarks
N/A