HP 10500 Series Configuration Manual page 130

Destination/Mask
1.1.1.9/32
172.1.1.0/24
[PE1] display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.9
Area 0.0.0.0 interface 172.1.1.1(Vlan-interface13)'s neighbors
Router ID: 2.2.2.9
State: Full
DR: 172.1.1.2
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 39
Neighbor is up for 00:00:29
Authentication Sequence: [ 0 ]
Neighbor state change count: 6
Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs:
2.
# Configure PE 1.
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
[PE1] interface vlan-interface 13
[PE1-Vlan-interface13] mpls enable
[PE1-Vlan-interface13] mpls ldp enable
[PE1-Vlan-interface13] quit
# Configure the P device.
[P] mpls lsr-id 2.2.2.9
[P] mpls ldp
[P-ldp] quit
[P] interface vlan-interface 13
[P-Vlan-interface13] mpls enable
[P-Vlan-interface13] mpls ldp enable
[P-Vlan-interface13] quit
[P] interface vlan-interface 12
[P-Vlan-interface12] mpls enable
[P-Vlan0interface12] mpls ldp enable
[P-Vlan-interface12] quit
# Configure PE 2.
[PE2] mpls lsr-id 3.3.3.9
[PE2] mpls ldp
[PE2-ldp] quit
[PE2] interface vlan-interface 12
[PE2-Vlan-interface12] mpls enable
[PE2-Vlan-interface12] mpls ldp enable
[PE2-Vlan-interface12] quit
Proto Pre Cost
OSPF 10 0
OSPF 10 1
Neighbors
Address: 172.1.1.2
Mode: Nbr is Master
BDR: 172.1.1.1 MTU: 0
sec
124
NextHop
1.1.1.9
172.1.1.1
GR State: Normal
Priority: 1
Interface
Loop0
Vlan13