Configuring Pe Dual Homing; Configuring A Dual-Homed Pe With Redundant Static Pws - HP 10500 Series Configuration Manual

Step
2. Enter Layer 2 Ethernet
interface view.
3. Create an Ethernet
service instance and
enter Ethernet service
instance view.
4. Bind the Ethernet service
instance to a VSI.

Configuring PE dual homing

This task includes the following configurations:
• Create a backup PW for the primary PW.
Specify whether to switch traffic from the backup PW to the primary PW when the primary PW
•
recovers, and the wait time for the switchover.
• Manually switch traffic from the primary PW to the backup PW.

Configuring a dual-homed PE with redundant static PWs

Step
1. Enter system view.
2. Enter VSI view.
3. Configure the VSI to establish
static PWs and enter VSI static
view.
4. (Optional.) Specify whether to
switch traffic from the backup
PW to the primary PW when
the primary PW recovers, and
the wait time for the
switchover.
5. Configure a VPLS PW and
enter VSI static PW view.
6. Configure a backup VPLS PW
and enter VSI static backup
PW view.
7. Return to user view.
8. Manually switch traffic of the
specified PW to its backup
PW.
Command
interface interface-type interface-number
service-instance instance-id
xconnect vsi vsi-name [ access-mode
{ ethernet | vlan } ] *
Command
system-view
vsi vsi-name
pwsignaling static
revertive { wtr wtr-time | never }
peer ip-address pw-id pw-id [ in-label
label-value out-label label-value ]
[ no-split-horizon | pw-class class-name
| tunnel-policy tunnel-policy-name ] *
backup-peer ip-address pw-id pw-id
in-label label-value out-label label-value
[ pw-class class-name | tunnel-policy
tunnel-policy-name ] *
return
l2vpn switchover peer ip-address pw-id
pw-id
272
Remarks
N/A
By default, no Ethernet service
instance exist on a Layer 2
Ethernet interface.
By default, a service instance is
not bound to any VSI.
Remarks
N/A
N/A
By default, no PW signaling
protocol is specified for the
VSI.
By default, when the primary
PW recovers, traffic is
immediately switched back
from the backup PW to the
primary PW.
By default, no VPLS PW is
configured.
By default, no backup VPLS
PW is configured.
N/A
N/A