Connect The Touch 10 Controller - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Connect the Touch 10 controller

Touch 10 must either be directly connected to the video system
as described on this page, or paired to the video system via
the network (LAN) as described on the next page. The latter is
referred to as remote pairing.
Connect Touch 10 directly to the video system
Connect Touch 10 to the video system's
2 or 3 Ethernet port as illustrated.
nd rd
Note that the video system does not
provide Power over Ethernet (PoE), so you
need a mid-span PoE injector to power
Touch 10.
Touch 10 set-up
Once Touch 10 is connected to power,
the set-up procedure begins. Follow the
instructions on screen.
If Touch 10 needs software upgrade,
new software will be downloaded from
the video system and installed on the
unit automatically as part of the set-up
procedure. Touch 10 restarts after the
upgrade.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Peripherals
(page 1 of 3)
SWITCH
PoE
injector
AP
Power
• 100-240 VAC
• 50/60 Hz
Contact information
The video system's
name or address is
displayed in the status
bar when Touch 10 is
successfully connected
to the video system.
Maintenance
Standard Ethernet cable
PoE rated Ethernet cable
The Ethernet connector
is behind the lid at the
rear of Touch 10.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
58
Administrator Guide
System settings Appendices
About the SX80 network
ports
SX80 has three network ports. Network
port 1 is reserved for the connection to
LAN, while Network ports 2 and 3 should
be used for peripherals like cameras and
Touch 10.
If you have more than two peripheral units
requiring an Ethernet connection, you
can insert an Ethernet switch between
Network port 2 or 3 and the peripherals.