Connect The Touch 10 Controller - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Connect the Touch 10 controller

Touch 10 must be paired to the video conferencing device via the
network (LAN). This is referred to as remote pairing.
Connect Touch 10 to the video conferencing
device via the network (LAN)
Connect Touch 10 and the video conferencing device to network wall
sockets or to a network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up procedure begins.
Follow the instructions on screen.
When the Select a room system screen appears, note the following:
• A list of devices signalling that they are available for paring will
show up on the screen. Tap the name of the device you want to
pair with.
Note that the following must be fulfilled for a device to show up
in the list:
• The device and Touch 10 must be on the same subnet.
• The device must have been restarted within the last 10
minutes. If the device does not appear in the list, try
restarting it.
• If the device does not appear in the list of available devices, enter
its IP address or hostname in the input field. Tap Connect.
• You have to log in with username and passphrase for the paring
process to commence. Tap Login.
A user with the USER role is sufficient; you do not need the
ADMIN role to perform this task.
Read more about how to create a user account and assign a role
to it in the ► User administration chapter.
If Touch 10 needs software upgrade, new software will be
downloaded from the device and installed on the unit automatically
as part of the set-up procedure. Touch 10 restarts after the upgrade.
D15330.16 SX10 Administrator Guide CE9.9, OCTOBER 2019.
Configuration Peripherals Peripherals
(page 1 of 3)
Power
• 100-240 VAC
• 50/60 Hz
Contact information
The video conferencing
device's name or address
is displayed in the status
bar when Touch 10 is
successfully paired to the
device.
Maintenance
SWITCH
PoE
injector
AP
The Ethernet connector
is at the rear of Touch 10.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
78
Administrator Guide
Device settings Appendices
Standard Ethernet cable
2
Standard Ethernet cable
PoE rated Ethernet cable
If the network infrastructure provides
1
Power over Ethernet (PoE), you do not
need a PoE injector; Touch 10 should
be connected directly to the wall socket
(Ethernet switch) with a PoE rated
Ethernet cable.
For safety, the PoE source must be in
the same building as Touch 10. The PoE
rated Ethernet cable can be up to 100 m
(330 ft).
2 SX10 can also be powered over Ethernet
if the network infrastructure supports
PoE. If so, you must use a PoE rated
cable.
Network
(LAN)
Network
(LAN)
1