Connect The Touch 10 Controller - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2

Introduction

Connect the Touch 10 controller

In order to use Touch 10 as user interface for
MX200 G2 and MX300 G2, Touch 10 must either be
directly connected to the video system as described on
this page, or paired to the video system via the network
(LAN) as described on the next page. The latter is
referred to as remote pairing.
Connect Touch 10 directly to the video
system
Connect Touch 10 to the video system as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up
procedure begins. Follow the instructions on screen.
If Touch 10 needs software upgrade, new software will
be downloaded from the video system and installed on
the unit automatically as part of the set-up procedure.
Touch 10 restarts after the upgrade.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Peripherals
(page 1 of 3)
Maintenance
Contact information
The video system's
name or address is
displayed in the top
banner when Touch
10 is successfully
connected to the video
system.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
41
Administrator Guide
System settings Appendices
PoE rated Ethernet cable
The Ethernet connector
is behind the lid at the
rear of Touch 10.